Map Light: Service and Repair

2005 Chrysler Sebring Convertible V6-2.7L VIN RSECTION Service and Repair
READING LAMP

REMOVAL
1. Disconnect and isolate battery negative cable.

Reading Lamp:




2. Using a trim stick, pry lamp from headliner.
3. Disconnect wire harness connector.
4. Pull bulb socket from lamp.
5. Pull bulb from socket.

INSTALLATION
1. Push bulb into socket.
2. Install bulb socket to lamp.
3. Install wire harness connector.
4. Install reading lamp to headliner.
5. Connect battery negative cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.