Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005SEBRING CONVERTIBLE V6-2.7L VIN RREPAIR AND DIAGNOSISINSTRUMENT PANEL, GAUGES AND WARNING INDICATORSINSTRUMENT CLUSTER / CARRIERSERVICE AND REPAIRPROCEDURESINSTRUMENT PANEL INBOARD BEZEL
2005 Chrysler Sebring Convertible V6-2.7L VIN R
Instrument Panel Inboard Bezel
2005 Chrysler Sebring Convertible V6-2.7L VIN RSECTION Instrument Panel Inboard Bezel
REMOVAL
1. Remove instrument panel center bezel.
2. Remove the one retaining screw located on the left side of the center stack, behind the center bezel.
3. Using a trim stick (special tool #C-4755) or equivalent, gently pry out on the instrument panel inboard bezel and remove.
INSTALLATION
1. Position the instrument panel inboard bezel over the retaining slots and firmly snap into place.
2. Install the one retaining screw located on the left side of the center stack, behind the center bezel.
3. Install the instrument panel center bezel.
1. Remove instrument panel center bezel.
Instrument Panel Inboard Bezel:
2. Remove the one retaining screw located on the left side of the center stack, behind the center bezel.
3. Using a trim stick (special tool #C-4755) or equivalent, gently pry out on the instrument panel inboard bezel and remove.
INSTALLATION
1. Position the instrument panel inboard bezel over the retaining slots and firmly snap into place.
2. Install the one retaining screw located on the left side of the center stack, behind the center bezel.
3. Install the instrument panel center bezel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.