Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005SEBRING CONVERTIBLE V6-2.7L VIN RREPAIR AND DIAGNOSISINSTRUMENT PANEL, GAUGES AND WARNING INDICATORSDASHBOARD / INSTRUMENT PANELSERVICE AND REPAIRLOWER INSTRUMENT PANELLEFT LOWER INSTRUMENT PANEL TRIM
2005 Chrysler Sebring Convertible V6-2.7L VIN R
Left Lower Instrument Panel Trim
2005 Chrysler Sebring Convertible V6-2.7L VIN RSECTION Left Lower Instrument Panel Trim
LEFT LOWER INSTRUMENT PANEL TRIM
REMOVAL
1. Using a trim stick (special tool #C-4755) or equivalent, gently pry out on the left instrument panel end cover and remove from vehicle.
2. Using a trim stick or equivalent, gently pry out on the power mirror switch bezel, disconnect the switch connector and remove.
3. Remove the five screws to the left lower instrument panel trim, Disengage one wiring connector to deck lid release and remove bezel from vehicle.
INSTALLATION
1. Connect the deck lid release switch connector.
2. Position the left lower instrument panel trim over the retaining slots and firmly push into place.
3. Install the five screws to the left lower instrument panel trim.
4. Connect the power mirror switch connector and position the bezel over the retaining slots and firmly snap into place.
5. Position the left instrument panel end cover over the retaining slots and firmly snap into place.
REMOVAL
1. Using a trim stick (special tool #C-4755) or equivalent, gently pry out on the left instrument panel end cover and remove from vehicle.
2. Using a trim stick or equivalent, gently pry out on the power mirror switch bezel, disconnect the switch connector and remove.
3. Remove the five screws to the left lower instrument panel trim, Disengage one wiring connector to deck lid release and remove bezel from vehicle.
INSTALLATION
1. Connect the deck lid release switch connector.
2. Position the left lower instrument panel trim over the retaining slots and firmly push into place.
3. Install the five screws to the left lower instrument panel trim.
4. Connect the power mirror switch connector and position the bezel over the retaining slots and firmly snap into place.
5. Position the left instrument panel end cover over the retaining slots and firmly snap into place.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.