Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005SEBRING CONVERTIBLE V6-2.7L VIN RREPAIR AND DIAGNOSISBODY AND FRAMEBODY CONTROL SYSTEMSBODY CONTROL MODULEDESCRIPTION AND OPERATIONFUNCTIONAL OPERATIONPOWER CONVERTIBLE TOP
2005 Chrysler Sebring Convertible V6-2.7L VIN R
Power Convertible Top
2005 Chrysler Sebring Convertible V6-2.7L VIN RSECTION Power Convertible Top
POWER CONVERTIBLE TOP
TOP CONTROL
The body control module controls all the functions of the convertible top. The body control module supplies a multiplexed voltage of approximately 90% of ignition voltage to the power top switch. Through a series of resistors the power top switch switches the circuit to ground depending on the position of the switch. The BCM then supplies the ground path for the up or down relay as requested. The power top switch has a 4.7K-ohm diagnostic resistor that allows the BCM to detect a possible open circuit.
WINDOW DROP RELAY ASSEMBLY
The convertible has a feature that allows the operator to lower all four windows and lower the top at the same time. This is accomplished by pressing the power top switch to the second detent. Through the multiplexed circuit of the power top switch the BCM will supply the ground for the window drop relay assembly.
The window drop relay assembly is comprised of four separate relays that are in series with the power window circuits. The relay assembly is located in the driver door.
TOP CONTROL
The body control module controls all the functions of the convertible top. The body control module supplies a multiplexed voltage of approximately 90% of ignition voltage to the power top switch. Through a series of resistors the power top switch switches the circuit to ground depending on the position of the switch. The BCM then supplies the ground path for the up or down relay as requested. The power top switch has a 4.7K-ohm diagnostic resistor that allows the BCM to detect a possible open circuit.
WINDOW DROP RELAY ASSEMBLY
The convertible has a feature that allows the operator to lower all four windows and lower the top at the same time. This is accomplished by pressing the power top switch to the second detent. Through the multiplexed circuit of the power top switch the BCM will supply the ground for the window drop relay assembly.
The window drop relay assembly is comprised of four separate relays that are in series with the power window circuits. The relay assembly is located in the driver door.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.