Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005SEBRING BASE, 2D COUPEREPAIR AND DIAGNOSISSTEERINGPOWER STEERINGSTEERING SYSTEM - COUPESTEERING WHEEL AND SHAFT ASSEMBLYDISASSEMBLY AND ASSEMBLYASSEMBLY SERVICE POINT>> A << STEERING LOCK CYLINDER/STEERING LOCK BRACKET/SPECIAL BOLT INSTALLATION
2005 Chrysler Sebring Base, 2D Coupe
>> A << Steering Lock Cylinder/Steering Lock Bracket/Special Bolt Installation
2005 Chrysler Sebring Base, 2D CoupeSECTION >> A << Steering Lock Cylinder/Steering Lock Bracket/Special Bolt Installation
CAUTION:
The steering lock bracket and bolts must be replaced with new ones when the steering lock is installed.
- When installing the steering lock cylinder and steering lock bracket to the column tube, temporarily install the steering lock in alignment with the column boss.
- After checking that the lock works properly, tighten the special bolts until the head twists off.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.