Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005CROSSFIRE SRT-6 V6-3.2L SC VIN NREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIR
2005 Chrysler Crossfire SRT-6 V6-3.2L SC VIN N
Power Window Switch: Service and Repair
2005 Chrysler Crossfire SRT-6 V6-3.2L SC VIN NSECTION Service and Repair
REMOVAL
WARNING: REFER TO RESTRAINTS BEFORE ATTEMPTING ANY DOOR, SEAT, STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Disconnect the negative battery cable.
2. Remove the shifter cover trim panel.
3. Disconnect the power window switch harness connector (1).
4. Squeeze the clips together and remove the power window switch from the shifter cover trim panel.
INSTALLATION
1. Install the power window switch to the shifter cover trim panel.
2. Connect the power window switch harness connector (1).
3. Install the shifter cover trim panel.
4. Connect the negative battery cable.
WARNING: REFER TO RESTRAINTS BEFORE ATTEMPTING ANY DOOR, SEAT, STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Disconnect the negative battery cable.
2. Remove the shifter cover trim panel.
3. Disconnect the power window switch harness connector (1).
4. Squeeze the clips together and remove the power window switch from the shifter cover trim panel.
INSTALLATION
1. Install the power window switch to the shifter cover trim panel.
2. Connect the power window switch harness connector (1).
3. Install the shifter cover trim panel.
4. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.