Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005CROSSFIRE SRT-6 V6-3.2L SC VIN NREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSOXYGEN SENSORSERVICE AND REPAIRDOWNSTREAM O2 SENSOR
2005 Chrysler Crossfire SRT-6 V6-3.2L SC VIN N
Downstream O2 Sensor
2005 Chrysler Crossfire SRT-6 V6-3.2L SC VIN NSECTION Downstream O2 Sensor
REMOVAL
1. Disconnect the negative battery cable.
NOTE: The left side O2 sensor is shown. The right side is similar.
2. Raise and support the vehicle.
3. Disconnect the O2 sensor harness connector.
4. Remove the O2 sensor (1).
INSTALLATION
1. Apply anti-seize compound to the threaded portion of the O2 sensor.
2. Install the O2 sensor (1). Tighten to 50 N.m (37 ft. lbs.).
3. Connect the O2 sensor harness connector.
4. Lower the vehicle.
5. Connect the negative battery cable.
1. Disconnect the negative battery cable.
NOTE: The left side O2 sensor is shown. The right side is similar.
2. Raise and support the vehicle.
3. Disconnect the O2 sensor harness connector.
4. Remove the O2 sensor (1).
INSTALLATION
1. Apply anti-seize compound to the threaded portion of the O2 sensor.
2. Install the O2 sensor (1). Tighten to 50 N.m (37 ft. lbs.).
3. Connect the O2 sensor harness connector.
4. Lower the vehicle.
5. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.