Removal-LHD

REMOVAL




1. Disconnect the negative battery cable (2).
2. Slide the clips forward to remove the plastic control module box cover (1).




3. Holding the metal body control module retaining clip (1) back, pull the body control module up and out of the control module box.




4. Disconnect the electrical connectors (1) by first sliding the grey windshield wiper connector lock to the right and removing the windshield wiper electrical connector. Then, pull the metal body control module connector lock up to unlock and disconnect the rest of the body control module electrical connectors.
5. Remove the body control module from the control module box (2).

INSTALLATION




1. Connect the electrical connectors (1) to the body control module and push the metal body control module connector lock down to lock the connector assembly. Then, connect the windshield wiper electrical connector to the body control module and slide the grey windshield wiper connector lock to the left to lock it.




2. Push the body control module into the control module box until the metal clip attaches to the body control module.




3. Install the plastic control module box cover (1) and slide the clips rearward to lock the cover.
4. Connect the negative battery cable (2).
5. After the BCM is installed it is necessary to either download information from the DRBIII�, or manually enter information received form TechTOOLS, or from STAR Hotline to program the new BCM. Choose Module Service Replacement from the DRBIII�menu. Choose the BCM Replacement option and follow the instructions on the scan tool screen. Pressing the ENTER key at any option screen will program the module after you have made all of your selections.