Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHRYSLER2005CROSSFIRE LIMITED, 2D COUPE, STANDARDREPAIR AND DIAGNOSISENGINE MECHANICALEXHAUST SYSTEMSUPPORT BRACKET AND ISOLATORINSTALLATION

2005 Chrysler Crossfire Limited, 2D Coupe, Standard

Support Bracket And Isolator: Installation

2005 Chrysler Crossfire Limited, 2D Coupe, StandardSECTION Installation

Fig 1: Removing/Installing Bracket Bolt, Bracket And Isolator From Exhaust Hanger

Courtesy of DAIMLERCHRYSLER CORP.

Position the bracket and bolt on the vehicle.
Tighten the bolt to 20 N.m (15 ft. lbs.).
Install the isolator and hanger.
Lower the vehicle.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.