Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005CROSSFIRE LIMITED, 2D COUPE, STANDARDREPAIR AND DIAGNOSISENGINE MECHANICALEXHAUST SYSTEMHEAT SHIELDSINSTALLATIONFRONT HEAT SHIELD
2005 Chrysler Crossfire Limited, 2D Coupe, Standard
Front Heat Shield
2005 Chrysler Crossfire Limited, 2D Coupe, StandardSECTION Front Heat Shield
- Position the heat shield on the floor pan.
- Install the heat shield nuts (1). Tighten the nuts to 10 N.m (89 in. lbs.).
- Install the front exhaust section. (Refer to EXHAUST SYSTEM/CATALYTIC CONVERTER - INSTALLATION) .
- Start the engine and check for exhaust leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.