Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005CROSSFIRE LIMITED, 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMEMISSIONS CONTROL SYSTEMAIR INJECTIONSWITCHOVER VALVEINSTALLATION
2005 Chrysler Crossfire Limited, 2D Coupe, Standard
Switchover Valve: Installation
2005 Chrysler Crossfire Limited, 2D Coupe, StandardSECTION Installation
- Position the new gasket between intake manifold and air pump switchover valve (1).
- Install the retaining bolt (4). Tighten bolt to 20 N.m (177 in. lbs.).
- Connect the vacuum line (3).
- Connect the air pump switchover tube (2).
- Install the air cleaner housing.
- Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.