Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005CROSSFIRE LIMITED, 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALPOWER DISTRIBUTIONRELAY CONTROL MODULEREMOVAL
2005 Chrysler Crossfire Limited, 2D Coupe, Standard
Relay Control Module: Removal
2005 Chrysler Crossfire Limited, 2D Coupe, StandardSECTION Removal
- Disconnect and isolate the negative battery cable.
- Open the lid to the control module box.
- Move the wires away to the side of the box to access the clip (1) that holds the relay control module in the control module box.
- Push the clip (1) back away from the relay control module and lift the relay control module out of the control module box.
- Remove all of the relay harness connectors from the relay control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.