Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHRYSLER2005CROSSFIRE LIMITED, 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSINTERIOR & EXTERIOR (SERVICE INFORMATION)CONVERTIBLE TOPRELEASE HANDLEREMOVAL

2005 Chrysler Crossfire Limited, 2D Coupe, Standard

Release Handle: Removal

2005 Chrysler Crossfire Limited, 2D Coupe, StandardSECTION Removal

Fig 1: Removing/Installing Release Handle

Courtesy of DAIMLERCHRYSLER CORP.

Rotate release handle clockwise (2) to gain access to the set screw (1).
Remove the release handle set screw.
Rotate the release handle back to its normal position and remove the release handle.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.