Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005CROSSFIRE LIMITED, 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)SECURITY SYSTEM MODULEREMOVAL
2005 Chrysler Crossfire Limited, 2D Coupe, Standard
Security System Module: Removal
2005 Chrysler Crossfire Limited, 2D Coupe, StandardSECTION Removal
- Disconnect the negative battery cable.
- Remove the trunk floor carpet.
- Remove the right side interior trim panel (4).
- Remove the upper right roof trim panel (1).
- Remove the rear interior trim panel (2).
- Remove the right half of the floor covering (3).
- Remove the sound deadening foam material from the central locking pump/security system module.
- Disconnect the air lines (2) and the electrical harness (1) from the central locking pump/security system module (3) and remove the module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.