Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005CROSSFIRE LIMITED, 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)POWERTRAIN CONTROL MODULESTANDARD PROCEDURESTANDARD PROCEDURE - PCM/SKREEM PROGRAMMINGPROGRAMMING IGNITION KEYS TO THE SENTRY KEY REMOTE ENTRY MODULE
2005 Chrysler Crossfire Limited, 2D Coupe, Standard
Programming Ignition Keys To The Sentry Key Remote Entry Module
2005 Chrysler Crossfire Limited, 2D Coupe, StandardSECTION Programming Ignition Keys To The Sentry Key Remote Entry Module
NOTE:
A maximum of eight keys can be learned to each Sentry Key Remote Entry Module. Once a key is learned to an Sentry Key Remote Entry Module it (the key) cannot be transferred to another vehicle.
- Obtain ignition keys to be programmed from the customer (8 keys maximum).
- Using the DRB III(R), erase all ignition keys.
- Program all of the ignition keys.
If ignition key programming is unsuccessful, the DRB III(R) will display a failure message.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.