Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005CROSSFIRE LIMITED, 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)POWER TOP CONTROL MODULEINSTALLATION
2005 Chrysler Crossfire Limited, 2D Coupe, Standard
Power Top Control Module: Installation
2005 Chrysler Crossfire Limited, 2D Coupe, StandardSECTION Installation
- Install the power top control module to the hydraulic pump bracket (4).
- Install the power top control module retaining screw (1).
- Connect the power top control module harness connectors (2) and (3).
- Install the trunk interior trim panel (1).
- Install the plastic panel retainers (2).
- Connect the negative battery cable.
- Perform the Standard Procedure to complete the installation and programing of the new power top control module. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/POWER TOP CONTROL MODULE - STANDARD PROCEDURE)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.