Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Central Locking Pump: Description
| 1 - AIR LINES |
| 2 - ELECTRICAL CONNECTORS |
| 3 - CENTRAL LOCKING PUMP/SECURITY SYSTEM MODULE |
The Central Locking Pump/Security System Module (3) is the pressure/vacuum supply pump for the power lock system. It is located in the right rear quarter panel area beneath the floor covering. For complete Central Locking Pump/Security System Module removal procedures, refer to REMOVAL .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.