Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005300 SRT-8REPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMDTCS P2098 TO P2174
2005 Chrysler 300 SRT-8
DTCS P2098 To P2174
2005 Chrysler 300 SRT-8SECTION DTCS P2098 To P2174
- Diagnosis And Testing
- P2098-Downstream Fuel Trim System 2 Lean
- P2099-Downstream Fuel Trim System 2 Rich
- P2100-Electronic Throttle Control Motor Circuit
- P2101-Electronic Throttle Control Motor Performance
- P2107-Electronic Throttle Control Module Processor
- P2108-Electronic Throttle Control Module Performance
- P2110-Electronic Throttle Control - Forced Limited Rpm
- P2111-Electronic Throttle Control - Unable To Close
- P2112-Electronic Throttle Control - Unable To Open
- P2115-Accelerator Pedal Position Sensor 1 Minimum Stop Performance
- P2116-Accelerator Pedal Position Sensor 2 Minimum Stop Performance
- P2118-Electronic Throttle Control Motor Circuit
- P2122-Accelerator Pedal Position Sensor 1 Circuit Low
- P2123-Accelerator Pedal Position Sensor 1 Circuit High
- P2127-Accelerator Pedal Position Sensor 2 Circuit Low
- P2128-Accelerator Pedal Position Sensor 2 Circuit High
- P2135-Throttle Position Sensor 1/2 Correlation
- P2138-Accelerator Pedal Position Sensor 1/2 Correlation
- P2161-VEHICLE SPEED SENSOR 2 ERRATIC (Not Equipped with ABS)
- P2161-VEHICLE SPEED SENSOR 2 ERRATIC (Equipped with ABS)
- P2166-Accelerator Pedal Position Sensor 1 Maximum Stop Performance
- P2167-Accelerator Pedal Position Sensor 2 Maximum Stop Performance
- P2172-High Airflow/Vacuum Leak Detected (Instantaneous Accumulation)
- P2173-High Airflow/Vacuum Leak Detected (Slow Accumulation)
- P2174-Low Airflow/Restriction Detected (Instantaneous Accumulation)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.