Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005300 SRT-8REPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE-SEAT MEMORYREMOVAL
2005 Chrysler 300 SRT-8
Module-Seat Memory: Removal
2005 Chrysler 300 SRT-8SECTION Removal
- Disconnect and isolate the battery negative cable.
- Remove the driver seat cushion/cover (2) (Refer to BODY/SEATS/SEAT CUSHION COVER - REMOVAL) .
- Pivot the module upward and disconnect the electrical connectors (1).
- Unsnap the memory seat module (4) from the side brackets.
- Pull the module rearward to remove it from the front of the seat frame (3).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.