Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE
Section 125 (Ignition Control)
WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition Control
- Description
- Specifications
- Torque
- Engine Firing Order - 3.7L V-6
- Engine Firing Order - 4.7L V-8
- Firing Order/Cable Routing - 5.7L V-8 Engine
- 8.3L - Firing Order
- Spark Plug Cable Resistance
- Spark Plugs
- Ignition Coil Resistance - 3.7L V-6
- Ignition Coil Resistance - 4.7L V-8
- Ignition Coil Resistance - 5.7L V-8
- Ignition Coil Resistance - 8.3L
- Ignition Timing
- Automatic Shut Down Relay
- Camshaft Position Sensor
- Ignition Coil
- Knock Sensor
- Spark Plug
- Ignition Coil Capacitor
- Spark Plug Cable
- Push-Button Starter Switch
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
