Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004TOWN & COUNTRY LIMITED, FWDREPAIR AND DIAGNOSISSUSPENSIONREAR SUSPENSIONSPRING MOUNTS - REARINSTALLATION
2004 Chrysler Town & Country Limited, FWD
Spring Mounts - Rear: Installation
2004 Chrysler Town & Country Limited, FWDSECTION Installation
CAUTION:
The following sequence must be followed when tightening the pin nuts on the rear hanger for the rear leaf spring. First the hanger pin nuts must be tightened to the specified torque. Then tighten the retaining bolts for the inner to outer half of the spring hanger to the specified torque. This sequence must be followed to avoid bending the spring hanger.
- For installation, reverse removal procedure. Do not tighten rear spring shackle nuts fully until vehicle is lowered and the full vehicle weight is applied to the rear wheels. Tighten rear spring mount bolts to 61 N.m (45 ft. lbs.). Tighten shackle nuts to 61 N.m (45 ft. lbs.).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.