Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Memory Systems: Operation: Notes
To recall desired memory position, vehicle must be in Park. Press and release appropriate memory selector switch button. The memory selector switch is located on driver's front door. Driver's seat and mirrors will return to stored position. Radio will have station presets programmed in memory and recall last station selected (even one not preset). Press buttons for .25-5.00 seconds. Do not press for more than 10 seconds. To program memory position to selector switch, see PROGRAMMING MEMORY POSITIONS IN DRIVER'S DOOR SWITCH under PROGRAMMING. To recall memory positions using Remote Keyless Entry (RKE) transmitters, press UNLOCK button on programmed transmitter. Up to 4 RKE transmitters can be used for each vehicle. Each RKE transmitter can retain only one of the 2 memory positions. To program memory position to RKE transmitter, see PROGRAMMING MEMORY POSITIONS IN REMOTE KEYLESS ENTRY SYSTEM under PROGRAMMING.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.