Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Riding Height Adjustment
Before adjusting alignment, check riding height. Measure height from inboard edge of fenderwell directly above center of wheel, unless specified otherwise. Riding height must be checked with vehicle on level floor, correct size tires properly inflated and fuel tank full. Bounce vehicle several times and allow suspension to settle.
Visually inspect vehicle for signs of abnormal height from front to rear and side to side. Check passenger and luggage compartments for extra-heavy items, and remove if present. Riding height specification information is not available from manufacturer. If riding height is abnormal, check, repair or replace suspension components as needed.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.