Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004SEBRING LIMITED, 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGMANUAL STEERINGSTEERING SYSTEM - COUPEPOWER STEERING GEAR BOX ASSEMBLYDISASSEMBLY AND ASSEMBLYASSEMBLY SERVICE POINTS>> N << BELLOWS BAND INSTALLATION
2004 Chrysler Sebring Limited, 2D Coupe, Standard
>> N << Bellows Band Installation
2004 Chrysler Sebring Limited, 2D Coupe, StandardSECTION >> N << Bellows Band Installation
- Turn the adjusting bolt of special tool MB991561 to adjust the opening dimension (W) to the standard value.NOTE: The dimension (W) is adjusted by approximately 0.7 mm per one turn.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.