Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004SEBRING LIMITED, 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSMANUAL HVAC SYSTEMS - COUPE
2004 Chrysler Sebring Limited, 2D Coupe, Standard
Manual HVAC Systems - Coupe
2004 Chrysler Sebring Limited, 2D Coupe, StandardSECTION Manual HVAC Systems - Coupe
- General Description
- Manual A/C Diagnosis
- Introduction To Heater, Air Conditioning And Ventilation Diagnosis
- Heater, Air Conditioning And Ventilation Diagnostic Troubleshooting Strategy
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: When the Ignition Switch is "ON," the A/C does not Operate.
- INSPECTION PROCEDURE 2: When the Air Outlet Changeover Control Knob is Moved to Defroster or Defroster/Foot Position, the A/C or the Inside/Outside Air Changeover Damper Motor does not Operate.
- INSPECTION PROCEDURE 3: When the A/C is Operating, Temperature Inside the Passenger Compartment does not Decrease (Cool Air not Emitted).
- INSPECTION PROCEDURE 4: Blower Fan and Motor does not Turn.
- INSPECTION PROCEDURE 5: Blower Fan and Motor does not Stop Turning.
- INSPECTION PROCEDURE 6: When the A/C is Operating Condenser Fan or Radiator Fan does not Turn.
- INSPECTION PROCEDURE 7: The A/C Indicator Flashes < Vehicles with 3.0L Engine >.
- Check At Automatic Compressor Controller Terminal
- Special Tools
- On-Vehicle Service
- Heater Control Assembly And A/C Switch
- Heater Unit, Heater Core, Blower Assembly And Evaporator Unit
- Blower Assembly And Resistor
- Evaporator Assembly
- Compressor Assembly And Tension Pulley
- Condenser And Condenser Fan Motor
- Refrigerant Line
- Ventilators
- Specifications
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.