Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004PT CRUISER TOURING, 2.4 B, AUTOMATICREPAIR AND DIAGNOSISSTEERINGSTEERING WHEEL & STEERING COLUMNIGNITION SWITCHINSTALLATION
2004 Chrysler PT Cruiser Touring, 2.4 B, Automatic
Ignition Switch: Installation
2004 Chrysler PT Cruiser Touring, 2.4 B, AutomaticSECTION Installation
- Ensure the ignition switch is in the RUN position and the actuator shaft in the lock housing is in the RUN position.
- Carefully install the ignition switch. The switch will snap over the retaining tabs. Install mounting screw. See Figure.
- Install electrical connectors to ignition switch.
- Install the multi-function switch and tighten the 2 screws. See Figure.
- Install upper and lower shrouds.
- Install key cylinder (cylinder retaining tab will depress only in the RUN position).
- Connect negative cable to battery.
- Install the air cleaner lid, connect the inlet air temperature sensor and makeup air hose.
- Check for proper operation of ignition switch and key-in warning switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.