Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004PT CRUISER TOURING, 2.4 B, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 66 (FRAME SYSTEM & BUMPER SYSTEM)FRONT FASCIAINSTALLATIONINSTALLATION - INTREPID
2004 Chrysler PT Cruiser Touring, 2.4 B, Automatic
Installation - Intrepid
2004 Chrysler PT Cruiser Touring, 2.4 B, AutomaticSECTION Installation - Intrepid
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Connect fog lamp wire connectors, if equipped.
- Place fascia pin position on vehicle, by fitting foam to bumper beam.
- Snap sides of fascia over drive pin fasteners on fenders.
- Install fasteners to upper radiator closure.
- Install fasteners attaching fascia to splash shields.
- Install fasteners attaching bottom of fascia to lower crossmember.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.