Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004PT CRUISER TOURING, 2.4 B, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 56 (IGNITION CONTROL SYSTEM)CAMSHAFT POSITION SENSORINSTALLATIONINSTALLATION - 2.7L
2004 Chrysler PT Cruiser Touring, 2.4 B, Automatic
Installation - 2.7L
2004 Chrysler PT Cruiser Touring, 2.4 B, AutomaticSECTION Installation - 2.7L
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
The camshaft position sensor is mounted in the front of the head. 4
- Install sensor in the chain case cover and push" sensor in until contact is made with the boss on the head. While holding the sensor in this position, install and tighten the retaining bolt to 12 N.m (105 in.lbs.) torque.
- Attach electrical connector to sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.