Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004PT CRUISER TOURING, 2.4 B, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 52 (ELECTRONIC CONTROL MODULES)ELECTRONIC CONTROL MODULESPROGRAMMING THE SKIM
2004 Chrysler PT Cruiser Touring, 2.4 B, Automatic
Programming The Skim
2004 Chrysler PT Cruiser Touring, 2.4 B, AutomaticSECTION Programming The Skim
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition switch on (transmission in park/neutral).
- Use the DRB III arid select THEFT ALARM, SKIM then MISCELLANEOUS.
- Select PCM REPLACED (GAS ENGINE).
- Program the vehicle four-digit PIN into SKIM.
- Select COUNTRY CODE and enter the correct country.NOTE: Be sure to enter the correct country code. If the incorrect country code is programmed into SKIM, the SKIM must be replaced.
- Select YES to update VTN (the SKIM will learn the VIN from the PCM).
- Press ENTER to transfer the secret key (the PCM will send the secret key to the SKIM).
- Program ignition keys to SKIM.NOTE: If the PCM and the SKIM are replaced at the same time, all vehicle keys will need to be replaced and programmed to the new SKIM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.