SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004PT CRUISER TOURING, 2.4 B, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 42 (ELECTRONIC CONTROL MODULES)ELECTRONIC CONTROL MODULESSTANDARD PROCEDURE - PCM/SKIM PROGRAMMINGPROGRAMMING IGNITION KEYS TO THE SKIM
2004 Chrysler PT Cruiser Touring, 2.4 B, Automatic

Programming Ignition Keys To The Skim

2004 Chrysler PT Cruiser Touring, 2.4 B, AutomaticSECTION Programming Ignition Keys To The Skim
WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch on (Transmission in park/neutral).
  2. Use the DRB III and select THEFT ALARM, SKIM then MISCELLANEOUS.
  3. Select PROGRAM IGNITION KEY'S.
  4. Enter secured access mode by entering the vehicle four-digit PIN.
    NOTE: A maximum of eight keys can be learned to each SKIM. Once a key is learned to a SKIM it (the key) cannot be transferred to another vehicle.

    If ignition key programming is unsuccessful, the DRB III will display one of the following messages:

    Programming Not Attempted-The DRB III attempts to read the programmed key status and there are no keys programmed into SKIM memory.

    Programming key failed (possible used key from Wrong Vehicle)-SKIM is unable to program key due to one of the following:

    • Faulty ignition key transponder
    • Ignition key is programmed to another vehicle.

    Keys Already Learned, Programming Not Done -SKIM Transponder ID memory is full.

  5. Obtain ignition keys to be programmed from customer (8 keys Maximum).
  6. Using the DRB III, erase all ignition keys by selecting MISCELLANEOUS and ERASE ALL CURRENT IGN. KEYS.
  7. Program all ignition keys.

    Learned key in ignition-ignition key transponder ID is currently programmed in SKIM memory.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.