Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004PT CRUISER TOURING, 2.4 B, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 28 (COMMON SPECS & PROCEDURES)AIR CONDITIONINGMANUAL SYSTEMTORQUE SPECIFICATIONS
2004 Chrysler PT Cruiser Touring, 2.4 B, Automatic
Torque Specifications
2004 Chrysler PT Cruiser Touring, 2.4 B, AutomaticSECTION Torque Specifications
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
MANUAL A/C TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| A/C Compressor Shaft Bolt | 11-14 (15-19) |
| A/C Compressor Line Manifold Fasteners | 17 (23) |
| A/C Compressor To Engine Block Bolts | 21 (28) |
| A/C Condenser To Refrigerant Lines | 17 (23) |
| INCH Lbs. (N.m) | |
| A/C Expansion Valve To Evaporator | 62 (7) |
| A/C Expansion Valve To Lines | 71 (8) |
| A/C Pressure Transducer | 53 (6) |
| Blower Motor Screws | 20 (2.2) |
| Door Actuator Screws | 20 (2.2) |
| HVAC Housing Screws | 20 (2.2) |
| HVAC Housing To Dash Panel Nuts (Engine Compartment Side) | 62 (7) |
| HVAC Housing To Dash Panel Nuts/Screws (Passenger Compartment Side) | 40 (4.5) |
| Receiver/Drier To Line Fasteners | 120 (13.6) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.