Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004PT CRUISER TOURING, 2.4 B, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 107 (2.7L ENGINE (SERVICE INFORMATION))VALVE TIMINGSTANDARD PROCEDUREENGINE TIMING - VERIFICATION
2004 Chrysler PT Cruiser Touring, 2.4 B, Automatic
Engine Timing - Verification
2004 Chrysler PT Cruiser Touring, 2.4 B, AutomaticSECTION Engine Timing - Verification
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, and 2004 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
Correct timing is critical for the NON free-wheeling designed, 2.7L engine. Engine timing can be verified by using the following procedures:
- Remove cylinder head covers. (Refer to REMOVAL ).
- Rotate engine until number one cylinder is at TDC on the EXHAUST stroke.
- View the intake camshaft sprocket timing mark. The mark should be 90° from the cylinder head cover sealing surface (Fig 1) on both right and left cylinder banks.
- Count chain pins from the mark on the intake camshaft towards the exhaust camshaft. Engine is timed correctly when there are 12 chain pins between the timing marks on the intake camshaft and exhaust camshaft (Fig 1).
- If marks are not correctly aligned, proceed to Timing Chain and Sprockets for service procedures. (Refer to REMOVAL ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.