Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004PT CRUISER TOURING, 2.4 B, AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM & WASHER SYSTEMREAR WIPER MOTORINSTALLATION
2004 Chrysler PT Cruiser Touring, 2.4 B, Automatic
Rear Wiper Motor: Installation
2004 Chrysler PT Cruiser Touring, 2.4 B, AutomaticSECTION Installation
Before installation activate wiper system to ensure the wiper module is in the PARK position. Position wiper arm so that the tip of the blade is on the park line on the glass.
NOTE:
When servicing the rear wiper motor, replace all three rubber well-nuts.
- Install three bolts to the rear wiper motor. Torque screws to 6.8 N.m (60 in. lbs.).
- Connect harness connector.
- Install liftgate trim panel. See BODY article.
- Install the arm on the pivot. See Figure .
- Install wiper arm retaining nut and torque to 18-20 N.m (160-175 in. lbs.).
- Install the rear wiper arm nut cap.
- Connect the battery negative cable.
- Close hood.
- Verify vehicle and system operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.