SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004PT CRUISER TOURING, 2.4 B, AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM & WASHER SYSTEMFRONT WIPER MOTORINSTALLATION
2004 Chrysler PT Cruiser Touring, 2.4 B, Automatic

Front Wiper Motor: Installation

2004 Chrysler PT Cruiser Touring, 2.4 B, AutomaticSECTION Installation
  1. Place the motor on the wiper linkage and install the three bolts to the front wiper motor.
  2. Reconnect the drive link to the motor crank ball joint.
  3. Place the front wiper module into cowl area and install the three mounting bolts. Torque the mounting screws to 8 N.m (75 in. lbs.). See Figure .
  4. Connect the front wiper motor posi-lock harness connector.
  5. Install the cowl cover. The right side cover overlaps the left side cover.
    1. Place the left side cowl cover into position and install the three push retainers.
    2. Place the right side cowl cover into position and install the four push retainers.
    3. Install the rear engine compartment seal at the cowl.

    Before installation of the front wiper arms, activate the wiper system to ensure the front wiper module is in the PARK position. Position wiper arms so that the tip of the driver's blade and the middle of the passenger's blade is on the park line on the windshield. See ADJUSTMENTS  .

  6. Place the arm on the pivot while the arm is in an over/centered position.
  7. Install the wiper arm retaining nut and torque to 21 N.m (190 in. lbs.).
  8. Install the wiper arm nut cap.
  9. Connect the battery negative cable.
  10. Close hood.
  11. Verify vehicle and system operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.