SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004PT CRUISER TOURING, 2.4 B, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALFUEL SYSTEMFUEL PUMP MODULEINSTALLATION
2004 Chrysler PT Cruiser Touring, 2.4 B, Automatic

Fuel Pump Module: Installation

2004 Chrysler PT Cruiser Touring, 2.4 B, AutomaticSECTION Installation
  1. Wipe seal area of tank clean. Place a new seal between the tank threads and the pump module opening.
    2. NOTE: The pump has to properly located to the tank for the fuel gauge to work properly.
  2. Position fuel pump module in tank. Make sure the alignment marks line up on the fuel tank and pump module.
    3. CAUTION: Over tightening the pump lock ring may result in a leak.
  3. While holding the pump module in position, install locknut. Tighten locknut to 74.5 N.m (55 ft. lbs) torque using special tool #6856.
  4. Install fuel tank, see FUEL TANK .
  5. Lower vehicle.
  6. Install the negative battery cable.
  7. Install the air cleaner lid, connect the inlet air temperature sensor and makeup air hose.
  8. Fill fuel tank with clean fuel. Use the DRBIII® scan tool to pressurize the system and check for leaks.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.