Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004CROSSFIRE STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 4 (ENGINE COOLING SYSTEM & AUTOMATIC TRANSMISSION COOLING SYSTEM)BELT TENSIONERINSTALLATION
2004 Chrysler Crossfire Standard
Belt TENSIONER: Installation
2004 Chrysler Crossfire StandardSECTION Installation
WARNING: This page is about a different variant/trim than selected.
- Position the belt tensioner (2) on the timing chain cover.
- Install the belt tensioner bolts (1). Tighten the bolts to 25 N.m (18 ft. lbs.).
- Install the accessory drive belt. See DRIVE BELT .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.