Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004300M SPECIAL V6-3.5L VIN KREPAIR AND DIAGNOSISLIGHTING AND HORNSFOG/DRIVING LAMPADJUSTMENTS
2004 Chrysler 300M Special V6-3.5L VIN K
Fog/Driving Lamp: Adjustments
2004 Chrysler 300M Special V6-3.5L VIN KSECTION Adjustments
Fig.14 Fog Lamp Unit Alignment Screen:
Fig.15 Lamp Unit Adjuster Screw-Intrepid:
Fig.16 Fog Lamp Unit Adjuster Screw-Concorde:
Fig.17 Fog Lamp Unit Adjuster Screw - 300M:
STANDARD PROCEDURE - FOG LAMP UNIT ALIGNMENT
Prepare an alignment screen. Refer to Electrical, Lamps/Lighting - Exterior, Headlamp, Adjustments for Alignment Screen Preparation. A properly aligned fog lamp will project a pattern on the alignment screen 100 mm (4 in.) below the fog lamp center line and straight ahead. To adjust fog lamp alignment, rotate the alignment screw, or.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.