Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2003SEBRING LXI, 2D CONVERTIBLEREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEBODY, CAB CONTROL SYSTEMSBODY DIAGNOSTIC PROCEDURES - EXCEPT COUPEDIAGNOSTIC INFORMATION AND PROCEDURESHEATING & A/CSYMPTOM: MODE DOOR FEEDBACK FAILUREPOSSIBLE CAUSES
2003 Chrysler Sebring LXi, 2D Convertible
Possible Causes
2003 Chrysler Sebring LXi, 2D ConvertibleSECTION Possible Causes
- CHECK CODE(S) PRESENT
- BLEND DOOR FEEDBACK FAILURE DTC PRESENT
- 5 VOLT SUPPLY CIRCUIT SHORTED TO GROUND
- 5 VOLT SUPPLY CIRCUIT OPEN
- 5 VOLT SUPPLY CIRCUIT SHORTED TO SENSOR GROUND CIRCUIT
- BODY CONTROL MODULE - 5 VOLT SUPPLY SIGNAL OPEN/SHORTED LOW
- MODE DOOR ACTUATOR SHORTED LOW
- 5 VOLT SUPPLY CIRCUIT SHORTED TO GROUND
- 5 VOLT SUPPLY CIRCUIT OPEN
- 5 VOLT SUPPLY CIRCUIT SHORTED TO SENSOR GROUND CIRCUIT
- BLEND DOOR ACTUATOR SHORTED LOW
- 5 VOLT SUPPLY CIRCUIT SHORTED TO VOLTAGE
- BODY CONTROL MODULE - 5 VOLTS SUPPLY HIGH
- SENSOR GROUND CIRCUIT OPEN
- MODE DOOR ACTUATOR OPEN
- SENSOR GROUND CIRCUIT OPEN
- BODY CONTROL MODULE
- MODE DOOR FEEDBACK SIGNAL CIRCUIT SHORTED TO GROUND
- MODE DOOR FEEDBACK SIGNAL CIRCUIT OPEN
- MODE DOOR FEEDBACK SIGNAL CIRCUIT SHORTED TO SENSOR GROUND CIRCUIT
- MODE DOOR ACTUATOR OPEN/SHORTED TO GROUND
- BODY CONTROL MODULE - MODE DOOR FEEDBACK SIGNAL OPEN/SHORTED TO GROUND
- MODE DOOR FEEDBACK SIGNAL CIRCUIT SHORTED TO VOLTAGE
- BODY CONTROL MODULE- MODE DOOR FEEDBACK SIGNAL SHORTED TO VOLTAGE
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.