Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2003INTREPID SXTREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINTERIOR/EXTERIOR TRIMINTERIOR TRIMREAR SHELF TRIM PANELREMOVAL
2003 Chrysler Intrepid SXT
Rear Shelf Trim Panel: Removal
2003 Chrysler Intrepid SXTSECTION Removal
- Remove seat cushion and back.
- Remove quarter trim lower and upper trim panels.
- Remove center seat belt anchor bolt.
- Remove push pin fasteners.
- Pull rear shelf trim panel away from rear glass to disengage clips (Fig 1 ).
- Disengage CHMSL wire connector, if equipped.
- Feed center seat belt and bezel through rear shelf trim panel
- Remove rear shelf trim panel from vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.