Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2003INTREPID SEREPAIR AND DIAGNOSISSUSPENSIONFRONT SUSPENSIONTENSION STRUT CRADLE BUSHINGINSTALLATION - TENSION STRUT CRADLE BUSHING
2003 Chrysler Intrepid SE
Installation - Tension Strut Cradle Bushing
2003 Chrysler Intrepid SESECTION Installation - Tension Strut Cradle Bushing
- Install tension strut cradle isolator bushing halve into front side of cradle mounting hole, until squarely seated against cradle (Figure).
- Install isolator bushing halve on tension strut until it is seated against retaining washer as shown (Figure).
- Reinstall the tension strut and lower control arm as an assembly back in the vehicle. (Refer to INSTALLATION - LOWER CONTROL ARM )
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.