System Description

2003 Chrysler Concorde V6-3.5L VIN MSECTION System Description
IDENTIFICATION OF SYSTEM
The vehicle systems that are part of the "body" system are:
- Airbag System
- Audio
- Chimes
- Climate Control Systems (Automatic and Manual)
- Door Ajar
- Electrically Heated Systems
- Exterior Lighting
- Instrument Cluster
- Interior Lighting
- Memory System
- Overhead Console
- Power Door Locks
- Remote Keyless Entry
- Speed Proportional Steering
- Vehicle Communications
- Vehicle Theft Security System
- Wiper/Washer

SYSTEM DESCRIPTION
The body system on the 2003 LH consists of a combination of modules that communicate over the PCI bus (Programmable Communication Interface multiplex system). Through the PCI bus, information about the operation of vehicle components and circuits is relayed quickly to the appropriate module(s). All modules receive all the information transmitted on the bus even though a module may not require all information to perform it's function. It will only respond to messages "addressed" to it through a binary coding process. This method of data transmission significantly reduces the complexity of the wiring in the vehicle and the size of wiring harnesses. All of the information about the functioning of all the systems is organized, controlled, and communicated by the PCI bus, which is described in the Vehicle Communication section of this general information.

Always begin by reading the diagnostic trouble codes using the DRB. Next, look for the symptom in the Diagnostic Information and Procedures of the Table Of Content located in the front. This will direct you to the specific test(s) that must be performed.

Important Note:
If the Powertrain Control Module has been changed and the correct VIN and mileage have not been programmed, a DTC will be set in the Airbag module. In addition, if the vehicle is equipped with a Sentry Key Immobilizer Module (SKIM), Secret Key data must be updated to enable starting. Refer to the 2003 LH Powertrain Diagnostic Manual for more information. Erase codes in all modules.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.