Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2002 Chrysler Neon LE, AutomaticFACTORY OEM SERVICE PROCEDURE

Speed Sensor - Output: Removal

Disconnect battery negative cable.
Raise vehicle on hoist.
Disconnect output speed sensor connector.
Unscrew and remove output speed sensor. (Fig 1).

Fig 1: Identifying Output Speed Sensor
Courtesy of DAIMLERCHRYSLER CORP.
Inspect speed sensor "O" ring and replace if necessary. (Fig 2).

Fig 2: Locating "O" Ring
Courtesy of DAIMLERCHRYSLER CORP.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty

Get a Free Quote

No obligation. See pricing before you book.