2002 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Removal & Installation: Engine: Installation

WARNING: This page is about a different variant/trim than selected.

To install, reverse removal procedure. Install NEW exhaust manifold "V" band clamps. DO NOT tighten engine mount bolts until all other engine block-to-transaxle housing bolts have installed. Tighten all fasteners to specification. See TORQUE SPECIFICATIONS . Add 8 qts (7.8L) of 50/50 mix of MOPAR® Extended Life Coolant (or equivalent) and distilled water. Bleed cooling system. See COOLING SYSTEM BLEEDING .

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.