Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler PT Cruiser Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Power Window Switch
- Remove suspect window switch. See POWER WINDOW SWITCH under REMOVAL & INSTALLATION. Using an ohmmeter, check switch continuity. See WINDOW SWITCH CONTINUITY table. See Fig 1 . Replace power window switch as necessary.
- Vehicles equipped with Auto Down feature have electronic components in front switch to actuate Auto Down. To test, check switch continuity, reconnect switch, turn ignition on and test front windows for Auto Down operation. If Auto Down does not work, replace front switch.
WINDOW SWITCH CONTINUITY
| Switch Position | Continuity Between Terminals No. |
|---|---|
| Off | 1 & 4; 2 & 5; 3 & 8 |
| Up | 1 & 4; 1 & 8; 2 & 5 |
| Down | 1 & 4; 1 & 5; 3 & 8 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.