2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Disassembly - Strut Assembly (Front)

WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.

The Strut assembly must be removed from the vehicle for it to be disassembled and assembled. Refer to REMOVALΒ  .

For the disassembly and assembly of the strut assembly, use strut spring compressor, Pentastar Service Equipment (PSE) tool W-7200, or the equivalent, to compress the coil spring. Follow the manufacturer's instructions closely.

WARNING: DO NOT REMOVE THE STRUT ASSEMBLY'S SHAFT NUT AT ANY TIME UNLESS THE COIL SPRING HAS BEEN PROPERLY COMPRESSED FOLLOWING THE PROCEDURE LISTED HERE.
  1. If both struts are being serviced at the same time, mark the coil spring and strut assembly according to which side of the vehicle the strut was removed from, and which strut the coil spring was removed from.
  2. Position the strut assembly in the strut coil spring compressor following the manufacturers instructions (Fig 1 ). The strut clevis bracket should be positioned outward. It will be necessary to turn the strut assembly so the steering arm will clear the compressor arm. Position the upper and lower hooks on the coil spring, then place a clamp on the lower end of the coil spring, so the strut is held in place once the strut shaft nut is removed (Fig 1 ).
    Fig 1: Positioning Strut Assembly in Compressor
    G03497898Courtesy of DAIMLERCHRYSLER CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.