Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Removal - Strut Assembly (Front)
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
DO NOT REMOVE THE STRUT ASSEMBLY'S SHAFT NUT AT ANY TIME UNLESS THE COIL SPRING HAS BEEN PROPERLY COMPRESSED FOLLOWING THE PROCEDURE LISTED IN STRUT ASSEMBLY DISASSEMBLY IN THIS SECTION.
- Raise vehicle on jackstands or centered on a frame contact type hoist.
- Remove front tire and wheel assembly from the vehicle.
- Remove the stabilizer bar link nut at the strut assembly. Remove the link from the strut assembly (Fig 1 ).
- Loosen, but do not remove, the outer tie rod end to strut arm attaching nut (Fig 2 ). Release outer tie rod end from steering arm using Puller, Special Tool C-3894A (Fig 2 ), then remove nut and tie rod from the steering arm.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
