Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Rocker Arms: Removal
WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, and 2003 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Remove cylinder head cover(s). (Refer to REMOVAL ).CAUTION: Always rotate engine by turning the crankshaft. Failure to do so will result in valve and/or piston damage.
- Rotate engine until the cam lobe is on its base circle (heel), on the rocker arm being removed.CAUTION: Depress valve spring only enough to remove rocker arm.
- Using Special Tools 8215 and 8216 Adaptor, depress valve spring only enough to release tension on rocker arm (Fig 1).
- Remove rocker arm from cylinder head.CAUTION: If rocker arms are to be reused, identify position of rocker arms for reassembly in their original positions.
- Repeat procedure for each rocker arm removed.
- Inspect the rocker arm for wear or damage. (Refer to INSPECTION ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.