Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal (Column Shift Models)
1999 Chrysler LHSSECTION Removal (Column Shift Models)
NOTE:
On column shift models, shift lever assembly may be serviced as a separate component of the steering column. When replacing shift lever assembly, a NEW shift interlock cassette must be installed.
- Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Ensure negative battery cable is disconnected from stud on shock tower and isolated from all other components.
- Place steering column in full down position. Unsnap upper steering column cover. Place steering column in full up position. Remove tilt lever. Remove screws retaining lower steering column cover. Remove lower cover. Remove center outlet bezel from instrument panel.
- Disconnect shift cable from pin on shift lever assembly. See Figure . Unlock shift cable adjuster.
- Remove shift lever assembly-to-tilt housing retaining screws. See Figure . Remove shift lever assembly from steering column tilt housing. Disconnect shift interlock cable from latch on shift mechanism. See Figure .
- Fully depress release tab on top of shift interlock cassette and slide shift interlock cassette from lock cylinder housing. See Figure . Discard shift interlock cassette.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.