Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Lower Control Arm, Ball Joint & Tension Rod: Removal
1999 Chrysler LHSSECTION Removal
- Raise vehicle and support. Remove wheels. Remove steering knuckle pinch bolt. Insert pry bar between lower control arm and steering knuckle. Push down on pry bar to separate ball joint stud from steering knuckle. Ensure ball joint dust boot is not damaged during removal.
- Remove tension rod-to-cradle attaching nut and washer from end of tension rod. Hold flat on tension rod using a wrench to keep rod from turning. Remove lower control arm pivot bushing-to-cradle assembly pivot bolt. Remove lower control arm and tension rod from cradle as an assembly. Remove tension rod from lower control arm.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.