Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Mirror Motor
Disconnect power mirror switch connector. See POWER MIRROR SWITCH under REMOVAL & INSTALLATION. Connect one end of a jumper wire to a 12-volt source and other end to specified power mirror switch connector terminals. Connect one end of another jumper wire to a good ground and other end to specified power mirror switch connector terminals. See POWER MIRROR MOTOR TEST table. If mirror does not operate as specified, check for open or shorted circuit or replace power mirror assembly. See Fig 1.
| Apply 12 Volts To Pin No. | Ground Pin No. | Mirror Operation (Right) | Mirror Operation (Left) | |||||
|---|---|---|---|---|---|---|---|---|
| Switch Connector (1) | ||||||||
| 12 | 6 | Up | ||||||
| 13 | 1 | Up | ||||||
| 6 | 12 | Down | ||||||
| 1 | 13 | Down | ||||||
| 6 | 7 | Right | ||||||
| 1 | 8 | Right | ||||||
| 7 | 6 | Left | ||||||
| 8 | 1 | Left | ||||||
| Door Connector(1) | ||||||||
| 6 | 2 | Up | Up | |||||
| 2 | 6 | Down | Down | |||||
| 2 | 5 | Right | Right | |||||
| 5 | 2 | Left | Left | |||||
| 1 | 3 | (2) | (2) | |||||
|
||||||||
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.